Call: (407) 944-8856

ROHN Tripod Roof Tower with 2-3/8 Mast R-TRTAG2

ROHN TRTAG2 Heavy Duty Tripod Roof Mount with 2.38 Mast
Made in the USA!
The TRTAG2 is a 5 foot total height Tripod Roof Tower, which comes with a 2-3/8 inch mast clearing 12 inches above the tripod apex. The legs are angled steel, Hot Dip Galvanized. With bolt-on swivel feet (mounting hardware, antenna not included).

Warranty Sheet

ROHN Tripod Roof Tower with 2.38 Mast R-TRTAG2

EZ46-3 Pitch Pad Kit with Screws - $3.95

EZ 46-3 Pitch Pad Kit with Screws

Made in the USA!
Complete with (3) 3 x 1.5" Moisture Barrier Pitch Pads and (6) 2 x 1/4" Hex Head Integral Washer Lag Screws for Weather-Proof Bracket Mounting to Exterior Surfaces. Most popular screw size for the majority of Antenna Mast Bracket Installations..
Read More

5' Foot X 1.25" OD 16 AWG Galvanized Antenna Mast Pole - Swaged | EZ 5-16S - $16.30

EZ 5-16S 5 Foot 16 AWG Swaged Antenna Mast Section
Made in the USA!
This 5 Foot (60") by 1.25" OD 16 AWG swaged end Antenna Mast tube is galvanized for weather and used to extend any 1-1/4 inch 16 gauge antenna masts by fitting the swaged end of this mast into the open end of the other mast tube, thereby extending the existing mast an additional 5 feet. Manufacturers recommend that masts heights of 10 feet and higher be guyed...

Tripod Antenna Mast Mounts

Tripod mounts offer fast, easy installation for one person. The legs adjust to any rafter spacing. Available in a range of sizes, tripods are shipped completely assembled with no loose parts so they can be quickly installed at your location.

Better reception, neat appearance with high quality self-supporting antenna mounts that eliminate signal distortion caused by inferior materials

Unmatched strength, durability and corrosion protection with heavy gauge,high quality, tubular steel uprights featuring the Sun-Coat process. This special triple-coating of zinc, chromate and polymer gives a smooth, shiny finish.