Call: (407) 944-8856

3/8TBE&E Turnbuckle for ROHN Tower 3/8 x 6 inch Eye to Eye

ROHN 3/8TBE&E 3/8" x 6" Eye to Eye Turnbuckle
Federal Spec FF-T-791B Type 1 Form 1; Forged, Hot Dip Glavanized, Open Body, Working Load Limit: 1200 lbs., The Turnbuckle eye is elongated to reduce stress on eye and make it easier for Thimbles and other hardware to pass through . Ultimate Strength: 6000 lbs.

Weather Resistant

Hot Dipped Galvanized Steel

Spec. Sheet

Typical Use: when attaching and tensioning ROHN Tower and Telescopic Antenna Mast Down Guy terminations (3/16" Strand via Pre-formed deadend and 5/16THH, 1/4" Bare Strand via Cable Clamps and 5/16THH, or 618/620 Bare Wire via Cable Clamps/Gripple and 1/4TH) to Equalizer Plate Anchors (Sandwich Plated like GAC305/EP25345 or GAC303/EP25343). Eye to Eye Turnbuckles typically attach the Tower Down Guy Strand (via a Big Grip Pre-Formed Dead-End and a Heavy Open Thimble) on one end to the Down Guy Equalizing Plate (the ones that use Bolts as the attachment Method, ie; R-GAC303, R-GAC305, EP25343 and EP25345) attached to the Anchor on the other end. Consult ROHN Catalog Links at Footer Section below for ROHN 25G 45G 55G 65G Tower Guy wire Details for Various Wind Loads.
Compare to ROHN R-3/8TBE&E 3/8 inch Eye to eye Turnbuckle and Channel Master Turnbuckle Part# 1369!

Specification Sheet

Spec Sheet

specifications

turnbuckle size

3/8"

Rate this product.

Product isn't rated yet. Write a review.

Tower Guy Wire Tension Guide

The recommended initial tension in guy wires is 10% of their ultimate tensile strength. There are two different grades of steel used for good guy line (clothes line does not count), HS (high strength) and EHS (extra high strength). The Rohn manual gives the following info on 3/16 and 1/4 in cable.