ROHN FRM238 Non-Penetrating Roof Mount 2.375 x 30 inch Mast Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast for placement of various TV, Radio, Microwave, WiFi and Wireless Internet Antennas. The base mount is 16 gauge Pre-Galvanized and the mast tube is thick-walled galvanized steel for corrosion protection and go together quickly. Antenna and wind loads vs ballast weight are found in the spec sheet below.
Height and Antenna Loading capability are dependant upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...
ROHN FRMPAD Protective Barrier Pad for FRM Mounts A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/8 thick Pad measures roughly 18 wide by 42 inches long, includes 2 each per set, place underneath Frame of Non-Penetrating mount, on top of Roof surface... Read More
VMP FRMA Non-Penetrating Roof Mount FRM200 to FRM238 Adapter
Converts the FRM200 2.00 inch OD mast pipe to a 2.375 inch OD Mount ideal for HughesNet, DirecWAY, StarBand Satellite Dish and Microwave Antenna Mounting, is constructed of steel, uses standard concrete blocks as Ballast...
VMP FRM200 Non-Penetrating Roof Mount with 2.00" O.D. Mast 30" in Length
Ideal for DirecTV Slimline, AT9, WildBlue and SuperDISH Dish Mounting, is constructed of steel, uses standard concrete blocks as Ballast...
3 Star FRM-238-30 Non-Penetrating Roof Mount with 2.375" O.D. Mast 30" in Length
Ideal for HughesNet, DirecWAY, StarBand Satellite Dish and Microwave Antenna Mounting, is constructed of steel, uses standard concrete blocks as Ballast...
ROHN TRTAG2 Heavy Duty Tripod Roof Mount with 2.38 mast Made in the USA!
The TRTAG2 is a 5 foot total height Tripod Roof Tower, which comes with a 2-3/8 inch mast clearing 12 inches above the tripod apex. The legs are angled steel, Hot Dip Galvanized. With bolt-on swivel feet (mounting hardware, antenna not included)...