Rohn RSL Tower Leg RSLL-R1 for section 1
This leg is one of the U legs that are found on the RSL Towers. This is for 1 Leg Only. 3 Legs Needed to complete a Section
Included:
*Per Rev G requirements, any structure greater than 10’ requires a climber safety device.
RSLSTEP Step Bolt Kit
Rohn RSL Tower Step Bolt kit consists of (10) 5/8” x 7” steps for one 10’ tower section. Order one kit for each section of tower for step bolts on one leg.
Read More
RACW Anti-Climb Brackets
Rohn RSL Tower Anti-Climb Brackets to be used with barbed or razor wire (wire not included). Kit includes (3) outer and (3) inner brackets with required mounting hardware.
Read More
Here you will find the individual tower legs for building or repairing an RSL tower section. These legs are 10' feet long and are made from U shaped galvanized 16 - 18 AWG steel. each leg is purchased as one unit. To make a complete section you will need to order quantity 3
All three tower legs in each section have provision to install step bolts and a safety climb system. When step bolts are desired, one step bolt kit must be ordered for each section of the tower. Increase the number of step bolt kits accordingly when step bolts are desired on more than one tower leg of a section
U-shaped legs allows for simple lap splice connection .Available in standard and heavy models. Pre-punched holes for attachment of safety climb systems, mounting kits, etc. Braces for each section are the same length, while bolt lengths are standard throughout the tower . Tower material is hot-dip galvanized
1. ROHN RSL Tower Leg for Section 1 | RSLL-R1 - $254.00 | 2. ROHN RSL 90 Foot Heavy Duty Angle Brace Tower Kit - RSL90AH20 - $6,325.00 |
3. ROHN Complete 160 Foot - 90 MPH - SSV Standard Tower - $0.00 | 4. ROHN Complete 40 Foot - 90 MPH - SSV Standard Tower - $0.00 |