ROHN BRM440 Non Penetrating Roof Antenna Mount R-BRM440
ROHN BRM440 Non-Penetrating Roof Mount 4.00 inch x 3 foot Mast
Mast Dimensions - 3-1/2” STD. Pipe (4 O.D.) x 34-1/4”
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 6' - 6" square with a 16” tray to fit concrete blocks, typically used as ballast. The base mount and mast pipe are Hot dip galvanized for corrosion protection and go together quickly.
Made in the USA!
Height and Antenna Loading capability are dependant upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.
ROHN Rubber Mat Layer for BRM4 Roof Mount R-BRM4MAT
- $110.00
ROHN BRM4MAT Protective Rubber Mat for BRM4 Roof Mount
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 1/8 thick Mat is for placement underneath the Frame of a BRM4 Non-Penetrating mount, on top of Roof surface...
ROHN Protective Barrier Pad for BRM4 Roof Mount R-BRM4PAD
- $164.00
ROHN BRM4PAD Protective Barrier Pad for BRM4 Roof Mount
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/8 thick Pad is for placement underneath the Frame of a BRM4 Non-Penetrating mount, on top of Roof surface...
