ROHN BRM665M Non-Penetrating Roof Mount 6-1/2 OD Mast Print this pagePrint this page
ROHN BRM665M Non-Penetrating Roof Mount 6-1/2 OD Mast
Price: $989.40

No penetration on roof surface
Hot Dip Galvanized for corrosion protection
Designed for concrete block ballast mount
Goes together quickly
Minimum of bolted connections
Optional roof pads or mats are available
Made in the USA!

Made in the USA!

Note: Height and Antenna Loading capability are dependant upon ballast weight. You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.
Availability: Usually ships in 3 weeks
Shipping: Can ship only within USA
Weight: 304 lb
ROHN BRM665M Non-Penetrating Roof Mount with 6.50 inch OD x 4 ft Mast
Made in the USA!Made in the USA!
Mast Dimensions - 6 inch STD. Pipe (6-5/8 OD) x 45 -3/4"
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 10' square with a 16" tray to fit concrete blocks, typically used as ballast. The base mount and mast pipe are Hot dip galvanized for corrosion protection and go together quickly.

Specification Sheet
Spec Sheet spec. sheet

Install Sheet install sheet