ROHN TA45 Tower Torque Arm Stabilizer Assembly

Anti-twist device located in the area of the Microwave or other Focused Beam antennas. Provides six-way guying. Bolts to tower at any section joint and attached with joint bolts. Must be installed as sections are joined together. The 45G tower can be used guyed, self-supporting or bracketed configurations according to specifications in the ROHN catalog. As a guyed structure, it can rise to a maximum of 300 feet. Consult ROHN Catalog Links at Footer Section below for ROHN 45G Tower Details.

NOTE:

You need (6) 1/2" Shackles to attach to the TA25 & TA45.  Big Grip and thimble would go around the shackle to terminate the wire.  The Big Grips and Thimbles  depend on the size of the Guy wire 3/16EHS ,1/4EHS or 5/16"EHS ( See Spec Sheet for Illustration ) 

Locate this Anti-twist device in the area of your Microwave Dish or Focused Beam Broadcast and Receive Antennas. Provides six-way guying, so be sure to account for the Total number of Guy wires appearing at each Tower Ground Anchor Location. Bolts to tower at any section joint, attached with joint bolts and must be installed as sections are joined together, so plan the Antenna Locations on the 45G Tower Before Assembly (Engineer their Wind Load accordingly). Install the Torque Arm Stabilizers as to not impede Installation or reception to other Antennas located on the same Tower or Adjacent Towers. Buy ROHN. Buy American.

Warranty Sheet