Rohn  10-16S 10 Foot HDG Swaged Tubing

 This ROHN  (120") by 1.25" OD 16 AWG Hot Dipped Galvanized Swaged Antenna Mast tube is galvanized for weather and used to extend any 1-1/4 inch 16 gauge antenna masts by fitting the swaged end of this mast into the open end of the other mast tube such as the EZ5-16 or the 1-1/4 - 16 gauge top-most tube section of telescopic antenna mast, thereby extending the existing mast an additional 10 feet. Sections can be Coupled Together as to Increase Height. Manufacturers recommend that masts heights of 10 feet and higher be guyed or provided additional Support. Fits a Variety of Mounts for Flexibility In Antenna Mounting and Height Clearance

.

120" Long Ships Truck Freight Only
 

There's a Big difference between 18 AWG and 16 AWG when it comes to Antenna Masts. This 16 AWG Mast is thicker, hardier, stronger and weighs more with heavier Pre-Galvanization. When considering the longevity of your HDTV Off-Air TV Antenna, there's no substitute for the strength of this mast in effectively transfering the Wind Load from the Antenna to the Mount in preventing the mast from Folding over. The 18 AWG painted masts just don't hold up. Be Sure and afford yourself 2 feet minimum, up to 1/4 of the overall mast length between the two wall mounts you would utilize in your TV antenna Installation. The Torque applied from wind load through cantilever to these mounts can be significant. This is one reason we no longer offer the 18 AWG masts such as the Channel Master CM-1805 or Cm-1810.

Warranty Sheet