ROHN 25G Bracketed Tower Wall Mount Kit

ROHN 25GWM Tower Wall Mount Bracket Kit

The ROHN 25GWM allows you to wall mount the base of a bracketed 25G tower. This wall mount gives you the ability to install more load than is typically available on a standard wall mount. The wall mount also helps to keep the ground area around the tower location usable. The R-25GWM assembly comes complete with both top and bottom wall mounting bracket materials and stub leg base plate for connection to a standard ROHN 25G tower section.

1. It is the purchaser’s responsibility to verify that their installation and building structure are able to withstand all loads

imposed by the antenna system and mount.

2. All antenna installations should be grounded, by installer, to meet all applicable codes.

3. All parts are hot-dip galvanized after fabrication.

4. All sealant to be supplied by others, if required.

5. Local zoning, building codes and insurance companies may require an architect or structural engineer’s approval

prior to installation.

6. Inspect the mount and antenna installation every 6 months and after severe weather.

7. Holes provided in mounting angles are 11/16” diameter for use with HDG 5/8“ threaded rod, provided by others.

Made in the USA!

ROHN Produces this series of Brackets specifically for the 25G Tower in exterior wall mount applications. Sturdy and Adjustable, this galvanized American Steel bracket is no comparison to the ROHN Clone brackets you may find at other Sites. Buy ROHN, Buy American.

Warranty Sheet