Printer View Tell a Friend

HOLLAND HDA-25 Full Spectrum 25 db Gain Amplifier

Highlights
High Input / Output
Switchable FM Trap
Low Distortion

Bulk Quantities Available Here!

Price: $29.95
Manufacturer Code: HDA-25
Stock Level: 0
Availability: See Related Products
Shipping: Can ship anywhere
HOLLAND HDA-25 HDTV DTV Digital Off-Air CATV Amplifier 54 to 1000 MHz
The HDA-25 is a 25 db Gain full spectrum high output, general purpose amplifier to meet the requirements of big and small Home or Office Distribution systems alike. The high output capability provides a lower distortion than economy models while maintaining quality and reliability for the most sophisticated applications. This Amplifier is for Indoor or Environmentally Protected Shelter use only. This Amplifier will serve 4 to 8 TV Sets and associated equipment well. It will not pass return signals associated with Cable TV Pay Per View, On Demand, Hi Speed Internet or other 2-way Communication Transactions.

spec. sheet



Spec. Sheet

Get Adobe Reader




If you need to Add a couple of HD Ready TV sets to your Cable TV Hook-up, this amp will do fine to Offset the Loss encountered when adding a splitter to feed the additional Outlets. It is extremely dependable and inexpensive to run. It is Forward only (54-1000 MHz), which matches the Bandwidth of any Cable TV System, but will not pass return from High Speed Internet Modems or Pay Per View Converter Boxes. We have Amplifiers that will do that... See Below! The Cable TV Company will be happy to Charge you to go through and Re-Install your Home, or you can do it yourself! With HD Digital Signals, the Signal Level is actually lower than the analog, and with increased Channel Capacity, not enough is there to feed your Home. Check Your Picture quality where the Cable TV feed enters your Home, if it's good there, you can replace connectors, cable and splitters to bring your installation up to the newest specifications. If you are feeding numerous TV sets or long Distances, use this Amplifier before the Splitter or  long cable run to maintain Signal Quality. If the Picture quality is Poor at the Feed point of your House (the Cable Company usually has a gray box used as a Demarcation Point for this Purpose), call your Cable TV Technician and Demonstrate to him your issues, so he can effect repair.
Specification Sheet
Spec Sheet
Product isn't rated yet. Write a review.

Pre-Amplifiers are mistakenly used with the rational that it will bring in Stations that weren´t there before... It won´t, and what´s worse, using the same antenna and pre-amp with FM and TV stations close by (0-30 miles) may overdrive the amp and actually impede your ability to provide goods signals to your TVs. If you desire to use a pre-amplifier, don´t use a high gain when you have local stations, get one with a FM trap to keep FM radio stations from over-driving the amp and remember that today´s Digital Signals don´t need to be high to get a picture. Some Pre-amps come Band Selective as well, realizing that the difference in antenna UHF/VHF gain means that one band needs to be amplified as opposed to the other. Use them to maintain Signal level to noise at the origin (your antenna) so that low signal levels from far away stations are not lost in a longer than average cable run to the location in the house where the signals would be further distributed to the TVs desired.

Amplifiers come with various gain numbers. Old Analog signals needed a high Carrier to Noise to get a high Signal to Noise Ratio of the Picture on your TV set, it was a one to one relationship and more was sometimes better. Digital Signals are lower in amplitude in comparison to Analog (a benefit) and that commensurately, the threshold at the TV is lower for a perfectly good picture. Very little in between, you either get a good picture or you don´t. Snow in the old analog pictures has been replaced by "Tiling" or little blocks within the picture not keeping up with the scene changes in today´s Digital TV viewing. Tiling is therefore today´s Digital Snow. It means (more often than not) that you are not far enough above the threshold of signal level into your TV to prevent little hiccups, drop-outs and interferences in signal from interrupting the Stream of Data. Remember that lots of things can happen from the Station on the way to your TV set!

The gain of a Line Amplifier should be selected to zero out the loss that follows it. In other words, if you have fifty feet of cable and a two-way splitter, then a 10 db amplifier will be fine. Conversely, if you have an eight-way splitter and hundreds of feet of cable, you will need an amplifier with a higher gain. Just as in the case of a Pre-Amplifier, however, bigger is not always better.

Products   Recently Viewed
My Cart
Credit Cards Taken
Your shopping cart is empty!
We Ship Fast!
Your Orders leave Daily! UPS... What can Brown do for You?!United States Postal ServiceR+L Carriers... Value Added Advantages!