CEILING PLATE FOR STANDARD 1-" N.P.T. PIPE - CP-2

Qty:

Add to Cart

ROHN BPH25G Hinged Tower Concrete Base Plate
Bolted to Concrete Pier as to Pivot Tower up or down from Base during Installation and Maintenance. Mounted to poured concrete pier via (6) 1/2 x 12 inch "J" bolts (sold separately)...

Qty:

Add to Cart

ROHN AS25G Tower Top Single Accessory Shelf
for Mounting Antenna Rotor, Beacon Lights and other Attachments. Drilled to fit the Hygain and Yaesu rotator bolt patterns. The plate is not drilled for nor is it designed for use with a thrust bearing. Field Drilling may be necessary to accomodate the Specific Item...

Qty:

Add to Cart

ROHN 25JBK Bolt Kit for 25G Tower Section
Hot Dip Galvanized like the tower section itself. Lasts Longer than the zinc plated versions. Perfect replacement bolt kit for high corrosion environments...

Qty:

Add to Cart

ROHN 25GSSB Self Supporting Base Plate
for Self-Supporting Tower Placement on a Concrete Pad depending on Wind Load. (Seek Engineering notes in Spec. Sheets) Mounted to poured concrete pier via (4) 5/8 x 12 inch "J" bolts (sold separately)...

Qty:

Add to Cart

ROHN BPL25G Top Bearing Plate for 25G Tower
Bolts to top of standard ROHN 25G Tower section. Pre-drilled to accept mounting for the ROHN Thrust Bearing TB3 (2 inch OD Mast Accomodation)...

Qty:

Add to Cart

ROHN TB50 Tower Bushing for 25AG 45AG Tower Section
Die Cast Reducer to Peen into ROHN Top Cap R-25AG R-45AG Mounting Tube to support 1.25" O.D. Mast...

Qty:

Add to Cart

ROHN RP25G Antenna Rotor Post for 25G Tower
For Mounting Antenna Rotors onto 1.25 DIA x 7.5 inch post. Fastens with Saddle Clamps to the Tower leg (also 1.25 inch DIA), with 4.75 inches of clear space between Tower Rail mount and Rotor Post...

Qty:

Add to Cart

ROHN SDB25G Base For Single Drive-In Ground Mount Tower Placement
allows the ROHN 25G Tower to be Mounted directly onto the Ground for Temporary Guyed or Bracketed Tower configurations...

Qty:

Add to Cart

ROHN ACWS Anti Climb Warning Sign
The same Anti Climb Warning Assembly Kit from the ROHN Factory for placement on new tower installations and replacement on existing tower sites where the sign and sticker have faded due to exposure. One of the items on your yearly checklist...

Qty:

Add to Cart

ROHN APL25G Tower Assembly Plate Top Beacon Plate
for Mounting Beacon Lights and Finishing Off Top of 25G Tower...