VMP FRM125 Non-Pen Roof Mount with 1.25" O.D. Mast 60" Length
is constructed of Powder Coated steel and uses standard concrete blocks to anchor on Flat Roof. Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DBS, antenna and satellite internet systems. Can be Used as a Penetrating Mount without Ballast. Compares to Other Name Brand Hardware at Half the Price.
This Non-Penetrating Mount Series from VMP is finished with a dark brown weather resistant powder coat inside and out that blends well with residential environments. With the 5 foot long, 1.25 inch O.D. pipe, you can mount HD TV Off-air antennas to be sure. With the 1.66 to 1.25 inch reducers available, you can also mount as applicable; DISH Network dishes, including 18" round dish, DIRECTV Oval, DISH 500, DISH 1000, DISH 1000.1, or both the TV antenna and the Satellite Dish on the same mast (with appropriate clearance and within reason). And as with all items in this Product Line, Screws and Pitch Pads are included for Bolt-down versus Ballast applications. The Length of the mast is 5 feet based on engineering that incorporates consideration for typical TV or Small Satellite Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
EZ 46-3 Pitch Pad Kit with Screws Made in the USA! Complete with (3) 3 x 1.5" Moisture Barrier Pitch Pads and (6) 2 x 1/4" Hex Head Integral Washer Lag Screws for Weather-Proof Bracket Mounting to Exterior Surfaces. Most popular screw size for the majority of Antenna Mast Bracket Installations.. Read More
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...
These mounts can be used where penetrating its attachment is not an option. Non penetrating mounts use a balasest like your usual cement cinder block as a method to hold down your masting structure. They can help meet the variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF reception.
Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose.
With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our mounts won't rust.
ROHN FRM125 Non-Penetrating Roof Mount 1.25 x 60 inch Mast Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast. The base mount and mast tube are 16 gauge Pre-Galvanized for corrosion protection.