Call: (407) 944-8856

Antenna Crossover Plate Kit

C-MT Crossover Mounting Plate Kit for Antennas

The Crossover Mounting plate , U-Bolt style consists of a Pre-Galvanized square Plate and all clamping hardware required for mounting of Antennas ( Wifi , TV Antennas , Direct TV , Dish Network ) the antennas are usually attached to tower legs , masts , Railings ( Balcony ,Roof Tops ). The U-Bolt style Crossover mounting plate mounts pipe size 1.00" to 2.38" horizontal or vertical to each other . Each Kit includes one (1) plate and four (4) U-Bolt Assemblies.

Features & Specification

Vertical or Horizontal Mounting

Pre-Galvanized Mounting Plate

Plate Dimensions 5" x 7"

U-Bolts Round Bend - 2 - 5/16" x 2-1/2 " Wide x 4-3/16" Long

- 2 - 1/4" x 2 " Wide x 3" Long

Kept Nuts - 8 ( 4 - 1/4" & 4 - 5/16" )

Maximum Tubing Size: 2.38 ". Outside Diameter

Rate this product.

Product isn't rated yet. Write a review.

Ground your Coaxial Cable System

Commensurate with Coaxial Cable TV Antenna and Satellite TV Splitter Installation, you want to Ground your Cable TV or HDTV Antenna Coaxial Cable System Outside before bringing the TV Cable Inside. This way, Lightning Strikes and Power Surges have an opportunity to arrest before reaching your Satellite Receiver and TV Set(s). The Integral Grounding Block designed onto most Outdoor Use Compatible Satellite Signal Splitter we sell will effectively convey this unwanted Electrical Energy to a Ground Rod via a Copper Ground Wire that you Install (not included). Consult your Local Building Code and NEC for guidance to Properly Grounding your HD TV Antenna, Satellite TV, Cable TV, WI-FI, Wireless Internet, Business Band, CB or Amateur Radio Antenna Installation.

Grounding & Bonding Are Important

Ground Blocks and Proper Grounding are an Important, often overlooked, aspect of Your Over-all Cable TV, HDTV or Satellite Antenna Installation and Safety. Proper Grounding can also Reduce the Reception of Interfering RF Signals. Grounding of Masts, Antennas, Cable TV and other RF Distribution Systems are covered by the NEC. Grounding can be as simple as a 12 AWG Ground Wire connected a short distance away to a 8 foot 5/8" DIA Copper Ground Rod (not supplied) or Bonded to the Existing Power Ground by the Power Meter installed on the side of your Home or Office. You may notice that most new Cable TV, Satellite and TV Antenna Installations are effected in this Manner. However, most State and some Local codes will contain requirements that supercede that of the NEC. Please Refer to Your Local Building and Electrical Codes...