3 Star Inc. EZ NP-30-166 Non-Penetrating Roof Mount - With 30" - 1.66" Mast Made in the USA!
Ideal for Light Off-Air TV and Wireless Internet Antenna mounting, is constructed of pre-galvanized steel, uses 6 standard concrete blocks to anchor, 29 x 35.5" base, with 1.66" mast 30" in length .
For light antenna loads needing 10 feet in height, use this mount in combination with (2)EZ 5-16S swaged 1.25" O.D. masts, several EZ 50 turnbuckles, some 620 guy wire and the EZ 43-A Guy Ring! (available separately)
Also can be used as a non-pen base for an H20 or H30 Telescopic mast, though down guys will still be required as per Factory recommendations.
EZ 46-3 Pitch Pad Kit with Screws Made in the USA! Complete with (3) 3 x 1.5" Moisture Barrier Pitch Pads and (6) 2 x 1/4" Hex Head Integral Washer Lag Screws for Weather-Proof Bracket Mounting to Exterior Surfaces. Most popular screw size for the majority of Antenna Mast Bracket Installations.. Read More
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...
3 Star 5992 6 Foot 1.66 O.D. Steel Satellite Dish Ground Pole Mast
Ideal as a DISH500 and DIRECTV Dish Antenna Mast (will NOT work for DIRECTVs SL3/5) for Ground or Wall mount Installation (Mount Not Included)...
EZ 43-A Adjustable 3-Way Down Guy Ring Made in the USA!
Adjustable mount Down Guy Ring, for 3-Way guying of Antenna masts with Screw Eye Bolts to affix 620 guy wire, Fits Masts up to 1 1/4" (Mast and Wire Not Included)...
VMP FRM125 Non-Penetrating Roof Mount with 1.25" O.D. Mast 60" in Length
Ideal for Off-Air TV and Wireless Internet Antenna mounting, is constructed of Powder Coated Steel steel, uses standard concrete blocks to anchor...
ROHN FRM125 Non-Penetrating Roof Mount 1.25 x 60 inch Mast Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast. The base mount and mast tube are 16 gauge Pre-Galvanized for corrosion protection.
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...