3 Star Inc 32816-7B Non-Penetrating Roof Mount with 1.66" OD x 30" Antenna Mast Pole
Is constructed of steel and uses standard concrete blocks for Ballast on Flat Roof. This Grey Powder Coat Finished Non-Penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Powder Coat Finished Steel Mast is 1.66 inches in Outside Diameter and 30 inches in Height from Base. Perfect for use with Super Dish systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.
Note: With the 30 inch long, 1.66 inch OD pipe, you can mount Super DISH, Dish 500, DirecTV or other Compatible Antenna. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Standard is a 1.66 or 1-5/8 inches Diameter Pipe size in most Universal Mounts for Satellite Dishes. Whether Aftermarket or Service Provider supplied, this mount can accomodate even large Dishes for DirecTV (1 and 3 LNB only, the World Direct International uses 1.75" DIA Mast and the Ka/Ku HD Band uses 2" DIA Mast), Dish Network 500+/1000+, Dish 500 Plus, Dish 1000 Plus, DishPLUS, Dish Network TurboHD 1000.4, Dish 1000.2, Dish Network 1000.4, DishPro, 105 SuperDISH, 121 SuperDISH, EchoStar Technologies Corporation, most FTA Free to Air and DBS Direct Broadcast Satellite Dishes that use the same Diameter Mounting Tube for mounting Dishes up to 39 inches. In addition, it can be used in mounting some smaller PCS, Cellular, Broadband Wireless, Wireless Internet and Two Way Antennas.The Length of the mast is 30 inches based on engineering that incorporates consideration for typical Dish Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.