3S-FRM-12510 Non-Penetrating Roof Mount - With 1.50" x 114" Mast ( 2 Piece )
Made in the USA!
Mast Dimensions - 1.50“ STD. Pipe (1-50" O.D.) x 120” (2 Piece mast 1.25"x 57") Ideal for Light Off-Air TV and Wireless Internet Antenna mounting, is constructed of pre-galvanized 12 ga. steel, uses 6 standard concrete blocks to anchor, 35" x 35" base, comes with 2 Pre-Galvanized Pipes ( 1.50" x 60" in length + 1.50" x 60" Swaged Pipe )
For light antenna loads needing 10 feet in total height, use this Optional Guy Support Accessories.
(1) EZ 60A-50' Steel Guy Wire
(1) EZ 43-A Guy Ring
(8) 1/8" CCF Guy Clamps
Height and Antenna Loading capability are dependent upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. It is Important to choose a Mount and Mounting Location with a Picture of the Finished Installation in Mind. Be Sure to First select a location that lends itself to applying a Load without Compromising the Integrity of the Material you affix to. Most Decorative Finishes most often do not have the Strength to Hold a Weight or Pressure without fail. Further, Think about what's underneath the exterior. Is it stronger, or will it yield to Pressure over time also? Weather Proof the Installation to Maintain the Integrity of your Home. Next consider the Location over a Lifetime of Adjustments, does it lend itself to modifications in Height or Direction? Larger Antennas increase the surface area presented to air movement, Hence, Wind-load does increase. As the length of the mast increases from Its last attached point on the structure, the torque applied in cantilever also increases with Weight and Wind-Load, requiring a more substantive attachment and Load-Bearing material. Keep the Distance Minimal from the Antenna to the TV's and Equipment you feed, as to minimize loss and the need for Amplification.
3 Star Inc's non-penetrating roof mounts meet a variety of communication tower needs. Our mounts will work for cellular, PCS, wireless cable, microwave, wireless internet, WiFi hot spots, DBS, MDS, MMDS and UHF/VHF reception.
Our non-pen roof mounts are designed and engineered to handle the job of getting above ground interference. Each mount has been researched and developed to serve a specific purpose.
Our non-penetrating roof mounts are either pre-galvanized or powder coated after fabrication meaning our roof mounts won't rust. With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards.