Non-Penetrating Roof Mount with Mast 1.25 OD by 60 inch
3 Star Inc 32816-7A Non-Penetrating Roof Mount with 1.25" OD x 60" Antenna Mast Pole
Is constructed of steel and uses standard concrete blocks to anchor. This Grey Powder Coat Finished Non-Penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Galvanized Steel Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DTV Off-Air Antenna and Wireless Internet systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.
Is constructed of steel and uses standard concrete blocks to anchor. This Grey Powder Coat Finished Non-Penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Galvanized Steel Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DTV Off-Air Antenna and Wireless Internet systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.
Note: With the 5 foot long, 1.25 inch OD pipe, you can mount HD TV Off-air Antennas to be sure. Mount Off-Air HDTV or Wireless Internet Antenna. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Length of the mast is 5 feet based on engineering that incorporates consideration for typical TV or Wireless Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
Specification Sheet
Spec Sheet
Your Cart
Products Search
We Ship Fast!
