2 FAN KIT FOR EREN SERIES VMP ENCLOSURES

Qty:

Add to Cart

ROHN FRM150 Non-Penetrating Roof Mount 1.50 x 30 inch Mast
Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast. The base mount and mast tube are 16 gauge Pre-Galvanized for corrosion protection.

Qty:

Add to Cart

ROHN TT-WG-500 TUF TUG Wire Cable Grab Fall Arrestor System
A Component designed to work within the TUF TUG Safety System. This is a Passive Fall Arrestor Dual Cam Wire Grab that will attach to your Harness and grab the steel strand running length-wise, up and down the Tower that was installed for this purpose...

ROHN TTFBH-2D TUF TUG Journeyman Climbing Harness with 4 "D" Rings
Part of the TUF TUG Safety System, Tower Climbing Harness...

Qty:

Add to Cart

ROHN R-340020 5/8" x 8' Bonded Ground Rod
Uniform Electrolytic Copper On Steel Core, Minimum Copper Depth 10 Mils, UL Listed. Use 5/8 inch Ground Rod Clamp for #6, #4 copper, use 3/4 inch clamp with steel wire rope (sold separately). Suitable for burial after attachment (see our self amalgamating tape sealant). Use for REV. F Grounding of Tower Base and Down Guys or Telescopic Antenna Masts. Select a ground rod clamp based on conductor to be attached (see details)...

Qty:

Add to Cart

ROHN FRMPAD Protective Barrier Pad for FRM Mounts
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/8 thick Pad measures roughly 18 wide by 42 inches long, includes 2 each per set, place underneath Frame of Non-Penetrating mount, on top of Roof surface...

3 Star GC-2 Tower Base Section Ground Clamp
Pipe Clamp (1.25 to 2.00 Inch OD) used for Ground Connection to 55G and 65G Fixed Rigid Base and Main Tower Sections. Can also used on Telescopic masts and 25G 45G...

Qty:

Add to Cart

3 Star CW12S #12 Solid Copper Ground Wire
25 feet of #12 Solid Copper wire as used for common grounding applications involving Low-Voltage Communications installations like Cable TV, TV Antenna, Satellite TV and Wireless Internet. Priced and sold by the foot in continuous roll (25 ft. per unit ordered)...

Qty:

Add to Cart

ROHN TTFBH-C/P TUF TUG Professional Climbing Harness with Seat
Part of the TUF TUG Safety System, Tower Climbing Harness...

Qty:

Add to Cart

RACW Anti-Climb Brackets
Rohn RSL Tower Anti-Climb Brackets to be used with barbed or razor wire (wire not included). Kit includes (3) outer and (3) inner brackets with required mounting hardware.

Qty:

Add to Cart

RSLSTEP Step Bolt Kit
Rohn RSL Tower Step Bolt kit consists of (10) 5/8” x 7” steps for one 10’ tower section. Order one kit for each section of tower for step bolts on one leg.