3 Star FRM125 Non Penetrating roof Mount 1.25" OD
is constructed of steel and uses standard concrete blocks to anchor. This Gray Powder Coat Finished Non-penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Galvanized Steel Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DTV Off-Air Antenna and Wireless Internet systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.
With the 5 foot long, 1.25 inch O.D. pipe, you can mount HD TV Off-air Antennas to be sure. Mount Off-Air HDTV or Wireless Internet Antenna. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Length of the mast is 5 feet based on engineering that incorporates consideration for typical TV or Wireless Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...