Non-Penetrating Roof Mount with 1.25" O.D. by 60" Mast

Description

3S 32816-7A Non-Penetrating Roof Mount with 1.25" O.D. Mast 60" in Length
is constructed of steel and uses standard concrete blocks to anchor. This Gray Powder Coat Finished Non-penetrating Roof Mount Base allows you to install dish antennas on flat roofs where no holes can be drilled. The heavy steel base is 34-3/4" square. Galvanized Steel Mast is 1.25 inches in Outside Diameter and 60 inches in Height from Base. For use with DTV Off-Air Antenna and Wireless Internet systems. Can be Used as a Penetrating Mount without Ballast when Field Drilled to use optional Pitch Pad Kit. Compares to Other Name Brand Hardware at Half the Price.

Spec.s

With the 5 foot long, 1.25 inch O.D. pipe, you can mount HD TV Off-air Antennas to be sure. Mount Off-Air HDTV or Wireless Internet Antenna. And with a little Field Drilling, Screws and Pitch Pads are available as an option for Bolt-down versus Ballast applications. The Length of the mast is 5 feet based on engineering that incorporates consideration for typical TV or Wireless Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.

Availability: Usually ships in 24 Hrs
Shipping: Can ship anywhere

Mount Accessories

The Video Mount Products Line features Versatile Mounting Options for a Wide Variety of Manufacturers and Models. By Size, here is a quick Application Chart:

Flat Panel Displays

Application	Large (42" - 63")	Mid (25" - 42")	Small (10" - 23")
Flush Wall	PDM-F or FP-LF	LCD-MID-F	LCD-F
Flush Wall / Tilt	PDM-FT	LCD-MID-FT	LCD-FT
Articulating Wall	PDM-W	LCD-2537	LCD-1
Ceiling	PDM-C	LCD-MID-C or LCD 2537C	LCD-1C
Desk	-	-	LCD-2
Dual Wall	-	-	LCD-WM2
Dual Ceiling	-		LCD-CM2
Dual Desk	-	-	LCD-DM2
Equipment Rack	-	-	ER-LCD1017
Pole	-	LCD-PA w/ LCD-2537	LCD-PA w/ LCD-1
Under Cabinet	-	-	LCD-UC1